Chrysler 2005 Crossfire SRT6 Service Manual page 1531

ZH
ANTI-THEFT TOW SENSOR SIGNAL CIRCUIT (CONTINUED)
2.
MEASURE THE VOLTAGE OF THE ANTI-THEFT TOW SENSOR SIGNAL CIRCUIT
Turn the ignition on.
Measure the voltage of the Anti-Theft Tow Sensor Signal circuit at the
Anti-Theft Tow Sensor harness connector.
Is voltage present?
Yes >> Repair the Anti-Theft Tow Sensor Signal circuit for a short
to voltage.
Perform VTSS VERIFICATION TEST.
No >> Go to 3
3.
MEASURE THE RESISTANCE OF THE ANTI-THEFT TOW SENSOR SIGNAL CIRCUIT
Turn the ignition off.
Measure the resistance between ground and the Anti-Theft Tow Sen-
sor Signal circuit at the Anti-Theft Tow Sensor harness connector.
Is the resistance below 10K ohms?
Yes >> Repair the Anti-Theft Tow Sensor Signal circuit for a short
to ground.
Perform VTSS VERIFICATION TEST.
No >> Replace the Anti-Theft Tow Sensor. (Refer to 8 - ELEC-
TRICAL/VEHICLE THEFT SECURITY/ANTI-THEFT TOW
SENSOR - REMOVAL).
Perform VTSS VERIFICATION TEST.
VEHICLE THEFT SECURITY - ELECTRICAL DIAGNOSTICS 8Q - 25