Chrysler 2005 Crossfire SRT6 Service Manual page 1007

ZH
*BRAKE WARNING INDICATOR INOPERATIVE (CONTINUED)
INDICATOR CIRCUIT OPEN
BRAKE FLUID LEVEL SWITCH
INDICATOR LAMP
INSTRUMENT CLUSTER
For a complete Instrument Cluster Circuit Diagram, (Refer to 8 - ELECTRICAL/INSTRUMENT CLUSTER - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
BRAKE WARNING INDICATOR SWITCH
Turn the ignition off.
Disconnect the Brake Fluid Level Switch harness connector.
Note: Check connectors - Clean/repair as necessary.
Connect a jumper wire between cavity 1 and cavity 2 of the Brake
Fluid Level Switch harness connector.
Turn the ignition on.
Is the Brake Warning Indicator lamp on?
Yes >> Replace the Brake Fluid Level Switch. (Refer to 5 -
BRAKES/ELECTRICAL/BRAKE FLUID LEVEL SWITCH -
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
INSTRUMENT CLUSTER - ELECTRICAL DIAGNOSTICS 8J - 53
POSSIBLE CAUSES