Chrysler 2005 Crossfire SRT6 Service Manual page 1418

8O - 62 RESTRAINTS - ELECTRICAL DIAGNOSTICS
LEFT SIDE IMPACT SENSOR SIGNAL CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on. The Occupant Restraint Controller (ORC) monitors the status of the Left
Side Impact Sensor Signal circuit.
• Set Condition: The DTC will set if a circuit failure is detected between the ORC and the Left Side Impact
Sensor.
FUSED IGNITION SWITCH OUTPUT CIRCUIT OPEN
LEFT SIDE IMPACT SENSOR SIGNAL CIRCUIT OPEN
LEFT SIDE IMPACT SENSOR SIGNAL CIRCUIT SHORT
LEFT SIDE IMPACT SENSOR
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
MEASURE LEFT SIDE IMPACT SENSOR FUSED IGNITION SWITCH OUTPUT VOLTAGE
Note: Inspect Fuse 2 located in the Underhood Accessory Fuse
Block. If the fuse is open, repair the cause of the open first
before continuing.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Disconnect the Left Side Impact Sensor harness connector.
Note: Check connectors - Clean/repair as necessary.
WARNING: TURN THE IGNITION ON, THEN RECONNECT THE
BATTERY.
Measure the voltage of the Fused Ignition Switch Output circuit at the
Left Side Impact Sensor harness connector.
Is the voltage above 10 volts?
Yes >> Go to 2
No >> Repair the Left Side Impact Sensor Fused Ignition Switch Output circuit.
Perform AIRBAG VERIFICATION TEST.
POSSIBLE CAUSES
ZH