Chrysler 2005 Crossfire SRT6 Service Manual page 877

ZH
5. Apply the epoxy through the slit in the masking tape or template. Overlap both ends of the break by at least 19
millimeters (0.75 inch).
6. For a terminal or pigtail wire replacement, mask the adjacent areas so the epoxy can be extended onto the
adjacent grid line as well as the bus bar. Apply a thin layer of epoxy to the area where the terminal or pigtail wire
was fastened and onto the adjacent grid line.
7. Apply a thin layer of conductive epoxy to the terminal or bare wire end of the pigtail and place it in the proper
location on the bus bar. To prevent the terminal or pigtail wire from moving while the epoxy is curing, it must be
wedged or clamped.
8. Carefully remove the masking tape or template.
CAUTION: Do not allow the glass surface to exceed 204° C (400° F) or the glass may fracture.
9. Allow the epoxy to cure 24 hours at room temperature or use a heat gun that will not over heat the glass. Hold
the heat gun approximately 25 centimeters (10 inches) from the repair.
10. After the conductive epoxy is properly cured, remove the wedge or clamp from the terminal or pigtail wire. Do
not attach the wire harness connectors until the curing process is complete.
11. Check the operation of the rear window defogger glass heating grid.
HEATED GLASS - SERVICE INFORMATION 8G - 17