Chrysler 2005 Crossfire SRT6 Service Manual page 1198

8L - 132 LAMPS/LIGHTING - INTERIOR - ELECTRICAL DIAGNOSTICS
*CARGO LAMP INOPERATIVE (CONTINUED)
FUSED B(+) CIRCUIT OPEN
GROUND CIRCUIT OPEN
CARGO LAMP BULB
For a complete Interior Lamps Circuit Diagram, (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR - SCHE-
MATICS AND DIAGRAMS).
Diagnostic Test
1.
INSPECT THE CARGO LAMP BULB
Note: If any BCM DTCs are set, diagnose them first before continuing.
Turn the ignition off.
Remove the Cargo Lamp Bulb and inspect for an open filament.
Is the Bulb filament open?
Yes >> Replace the Cargo Lamp bulb. (Refer to 8 - ELECTRICAL/LAMPS/LIGHTING - INTERIOR/CARGO
LAMP - REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Go to 2
2.
MEASURE CARGO LAMP VOLTAGE
Disconnect the Cargo Lamp harness connector.
Note: Check connector - Clean/repair as necessary.
Measure the voltage between ground and the Cargo Lamp harness
connector cavity 2.
Is the voltage above 10 volts?
Yes >> Go to 3
No >> Repair the Fused B(+) circuit for an open.
Perform BODY VERIFICATION TEST.
POSSIBLE CAUSES
ZH