Chrysler 2005 Crossfire SRT6 Service Manual page 1334

8N - 104 POWER SEATS - SERVICE INFORMATION
INSTALLATION - FRONT RISER MOTOR
1. Position the front riser motor so that the notch (3)
is aligned as shown.
2. Install the front riser motor attachment screws (2).
Tighten the motor screws to 4 N·m (35 in. lbs.).
3. Connect the front riser motor harness connector.
4. Install the front seat. (Refer to 23 - BODY/SEATS/
SEAT - INSTALLATION).
5. Connect the negative battery cable.
RECLINER MOTOR
REMOVAL
1. Disconnect the negative battery cable.
2. Remove the seat back cover enough to expose the
recliner motor. (Refer to 23 - BODY/SEATS/SEAT
BACK COVER - REMOVAL).
3. Remove the bolt (1) attaching the recliner motor to
the seat back frame.
4. Disconnect the recliner motor harness connector
(2).
ZH