ZH
1. Disconnect the negative battery cable.
2. Remove the door interior trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - REMOVAL).
3. Carefully peel back the door watershield enough to
expose the driver door lock switch.
4. Release the locking tab (1) attaching the driver
door lock switch to the door latch assembly.
5. Disconnect the pneumatic supply line (2) from the
door lock actuator.
6. Disconnect the remaining door harness connectors,
and remove the driver door lock switch.
INSTALLATION
Note: Ensure the harness is routed and secured in
its original position to avoid potential interference
with moving parts.
1. Install the door harness assembly into the door.
2. Install the driver door lock switch into the door latch
assembly (1).
3. Install the door watershield.
4. Install the door interior trim panel. (Refer to 23 -
BODY/DOOR - FRONT/TRIM PANEL - INSTALLA-
TION).
5. Connect the negative battery cable.
POWER LOCKS - SERVICE INFORMATION 8N - 41