ZH
PASSENGER SEAT BELT TENSIONER SQUIB CIRCUIT (CONTINUED)
8.
MEASURE THE RESISTANCE OF THE PASSENGER SEAT BELT SQUIB LINE 1 CIRCUIT
WARNING: TURN THE IGNITION OFF, DISCONNECT THE BAT-
TERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
Measure the resistance between ground and the Passenger Seat Belt
Squib Line 1 circuit.
Is the resistance below 10K ohms?
Yes
>> Repair the Passenger Seat Belt Squib Line 1 circuit for a
short to ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No
>> Go to 9
9.
MEASURE THE RESISTANCE OF THE PASSENGER SEAT BELT SQUIB LINE 2 CIRCUIT
With the ignition off.
Measure the resistance between ground and the Passenger Seat Belt
Squib Line 2 circuit.
Is the resistance below 10K ohms?
Yes
>> Repair the Passenger Seat Belt Squib Line 2 circuit for a
short to ground.
Perform AIRBAG VERIFICATION TEST.
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
No
>> Replace the Occupant Restraint Controller. (Refer to 8 -
ELECTRICAL/RESTRAINTS/OCCUPANT
CONTROLLER - REMOVAL).
WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED AT ANY TIME, IT MUST BE
REPLACED.
Perform AIRBAG VERIFICATION TEST.
RESTRAINTS - ELECTRICAL DIAGNOSTICS 8O - 21
RESTRAINT