Chrysler 2005 Crossfire SRT6 Service Manual page 1249

ZH
NO COMMUNICATION WITH BODY CONTROL MODULE AND CENTRAL LOCKING PUMP/SECURITY SYS-
TEM MODULE (CONTINUED)
2.
MEASURE THE RESISTANCE OF THE CAN B BUS (-) CIRCUIT
Measure the resistance of the CAN B Bus (-) circuit from the CLP/
SSM C1 harness connector to the BCM harness connector.
Is the resistance below 1.0 ohm?
Yes >> Replace the Central Locking Pump/Security System Mod-
ule. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECU-
RITY/SENTRY
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the CAN B Bus (-) circuit for an open.
Perform BODY VERIFICATION TEST.
KEY REMOTE ENTRY
POWER LOCKS - ELECTRICAL DIAGNOSTICS 8N - 19
MODULE -