Chrysler 2005 Crossfire SRT6 Service Manual page 1392

8O - 36 RESTRAINTS - ELECTRICAL DIAGNOSTICS
RIGHT SIDE AIRBAG SQUIB CIRCUIT (CONTINUED)
When Monitored and Set Condition
• When Monitored: Ignition on. The Occupant Restraint Controller (ORC) monitors the resistance of the Right
Side Squib circuits.
• Set Condition: The ORC has detected abnormally high voltage, low resistance, high resistance or an open
circuit on one or both of the Right Side Squib circuits.
RIGHT SIDE SQUIB CIRCUIT(S) OPEN
RIGHT SIDE SQUIB CIRCUIT(S) SHORT TO VOLTAGE
RIGHT SIDE SQUIB CIRCUIT(S) SHORT TO GROUND
RIGHT SIDE SQUIB CIRCUITS SHORT TO EACH OTHER
RIGHT SIDE AIRBAG SQUIB
OCCUPANT RESTRAINT CONTROLLER
For a complete Restraints System Circuit Diagram, (Refer to 8 - ELECTRICAL/RESTRAINTS - SCHEMATICS AND
DIAGRAMS).
Diagnostic Test
1.
WITH THE DRB III , READ DTCs
Note: When reconnecting the Airbag System components, the
ignition must be turned off and the battery must be disconnected.
Note: Ensure the battery is fully charged.
Turn the ignition on.
With the DRB III , select ACTIVE or STORED DTCs.
Is the DTC ACTIVE?
Yes >> Go to 2
No >> Go to 10
POSSIBLE CAUSES
ZH