Chrysler 2005 Crossfire SRT6 Service Manual page 722

8E - 20 ELECTRONIC CONTROL MODULES - ELECTRICAL DIAGNOSTICS
*NO RESPONSE FROM INSTRUMENT CLUSTER (CONTINUED)
3.
FUSED B+ CIRCUIT OPEN
Turn the ignition off.
Disconnect the IC C1 harness connector.
Note: Check connector — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused B+ circuit at the IC C1 harness con-
nector.
Is the voltage above 10 volts?
Yes >> Go to 4
No >> Repair the Fused B+ circuit for an open.
Perform BODY VERIFICATION TEST.
4.
FUSED IGNITION SWITCH OUTPUT CIRCUIT(S) OPEN
Turn the ignition off.
Disconnect the IC C2 harness connector.
Note: Check connector — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the Fused Ignition Switch Output circuits at the
IC C1 and C2 harness connectors.
Is the voltage above 10 volts?
Yes >> Go to 5
No >> Repair the Fused Ignition Switch Output circuit(s) for an
open.
Perform BODY VERIFICATION TEST.
ZH