Chrysler 2005 Crossfire SRT6 Service Manual page 1246

8N - 16 POWER LOCKS - ELECTRICAL DIAGNOSTICS
CLP/SSM SYSTEM OVERVOLTAGE (CONTINUED)
3.
MEASURE THE RESISTANCE OF THE GROUND CIRCUIT
Turn the ignition off.
Measure the resistance between ground and the Ground circuit at the
CLP/SSM C2 harness connector.
Is the resistance below 1.0 ohm?
Yes >> Replace the Central Locking Pump/Security System Mod-
ule. (Refer to 8 - ELECTRICAL/VEHICLE THEFT SECU-
RITY/SENTRY
REMOVAL).
Perform BODY VERIFICATION TEST.
No >> Repair the Ground circuit for an open.
Perform BODY VERIFICATION TEST.
4.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTC's.
Note: Check for any Technical Service Bulletins that may apply.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the
wires while checking for shorts and open circuits.
Were there any problems found?
Yes >> Repair as necessary.
Perform POWER TOP CONTROL MODULE VERIFICATION TEST.
No >> The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for
a possible intermittent condition.
KEY REMOTE ENTRY MODULE -
ZH