Modify Nas Interface - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.8 NAS Management
The procedure to delete NAS interfaces is as follows:
Procedure
1
Select the NAS interface that is to be deleted (multiple selections can be made) and click
[Delete] in [Action].
 A confirmation screen appears.
2
Click the [OK] button.
 Deletion of NAS interface starts.
3
Click the [Done] button to return to the [NAS Interface] screen.
4.8.6

Modify NAS Interface

This function changes the NAS interface settings.
This function is used in a Unified Storage environment.
If the NAS interface modification has not been completed successfully, wait for the ETERNUS DX S3 series
status to return to normal and then try again.
To use the Active-Active connection, specify different IP addresses on the same subnetwork for the ports of
each CM that will be duplicated.
For details on the parameters for this function, refer to
The procedure to modify the NAS interface settings is as follows:
Procedure
1
Select the NAS interface that is to be changed, and click [Modify] in [Action].
510
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.4.7.4 Modify NAS Interface" (page
End of procedure
892).
P2X0-1270-13ENZ0