Fujitsu ETERNUS DX60 S3 User Manual page 38

Chapter 1 System Management
1.4 System Management
The procedure to set the Box ID is as follows:
Procedure
1
Click [Change Box ID] in [Action].
2
The current Box ID setting appears. To change the value, enter a new Box ID.
The main setting item is as follows.
●
Change Box ID
• Box ID
If an error screen appears under the following conditions, check the parameter settings.
• A Box ID is not input
• The entered value of a Box ID contains a character other than alphabetic characters (upper case),
numeric characters, hash key characters (#), or spaces
3
Click the [Set] button.
 A confirmation screen appears.
4
Click the [OK] button.
 The specified Box ID is registered.
5
Click the [Done] button to return to the [System Settings] screen.
If the Box ID entered is less than 40 characters, a "#" hash key character is appended to the Box ID for
each character short. Then, the 40-digit Box ID is registered in the ETERNUS DX.
38
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1270-13ENZ0