Setup Remote Session Permission - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.14 Remote Support Management (AIS Connect)
6
Click the [Done] button to return to the screen when starting this function in
1.14.2

Setup Remote Session Permission

This function performs permission settings for remote sessions with the AIS Connect function. If a remote ses-
sion is permitted, remotely controlling the ETERNUS DX from a remote server (AIS Connect server) becomes
available.
• Settings can be changed when "AIS Connect" is enabled. Refer to
(page 206)
• The permission setting of a remote session is released if one of the following conditions applies:
- When a remote session is not detected before the timeout period that is specified for the timeout
setting
- When this function forbids remote sessions
- When "AIS Connect" is disabled
• The permission settings are retained even if the ETERNUS DX is rebooted or after recovery from a power
failure. Note that the timer that monitors remote session connection is reset to "0"in this case.
• If the setting of this function is changed to forbid while a remote session is being performed, operations
for this remote session are permitted until the user logs out. However, once this remote session is logged
out from, this remote session cannot be logged into while the remote session is forbid.
• When "AIS Connect" is disabled, all remote sessions that are currently being performed are immediately
disconnected.
For details on the parameters for this function, refer to
777).
For the factory default settings for this function, refer to
986).
The procedure to set the remote support permission is as follows:
Procedure
1
Click [Setup Remote Session Permission] in [Action].
for details.
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"1.14.1 Setup AIS Connect Environment"
"A.1.12.6 Setup Remote Session Permission" (page
"Appendix B Setup Remote Session Permission" (page
209
Step 1.
End of procedure
P2X0-1270-13ENZ0