Fujitsu ETERNUS DX60 S3 User Manual page 708

Appendix A Parameter List
A.1 System Management
●
Allowable IP Address
• Connect IP Address
Description
Input condition/
Display contents
• Length of Subnet Prefix
Description
Input condition/
Display contents
A.1.7.2 Setup Firewall
For details about this function, refer to
For the factory default settings for this function, refer to
●
Firewall Settings
Configure a firewall for each acceptable protocol.
The input conditions and the display contents for the firewall settings are as follows:
Input condition/
Display contents
• HTTP
Description
• HTTPS
Description
Input the connect IP address for the remote storage system.
"Global address", "unique local address", or "6to4 address" can be input for the IP
address. Refer to "Available IPv6 Address" (page 107)
Make sure to input "Connect IP Address" and "Length of Subnet Prefix" together.
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation (Setup Network Environment)" (page 107)
Input the prefix length of the connect IP address for the remote storage system (unit:
bit).
Refer to "Available IPv6 Address" (page 107)
•
Numeric characters
•
3 - 128
"1.8.2 Setup Firewall" (page
Checkbox
•
Selected
Enable
•
Cleared
Disable
Specify whether to enable or disable the HTTP connection.
HTTP is used when accessing from ETERNUS Web GUI.
Specify whether to enable or disable the HTTPS connection.
HTTPS is used when accessing from ETERNUS Web GUI. This connection uses the data
encryption for data transferring.
708
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
for details.
for details.
109).
"Appendix B Setup Firewall" (page
for details.
980).
P2X0-1270-13ENZ0