Fujitsu ETERNUS DX60 S3 User Manual page 720

Appendix A Parameter List
A.1 System Management
• Retry Interval
Description
Input condition/
Display contents
A.1.7.11 Setup Syslog
For details about this function, refer to
For the factory default settings for this function, refer to
●
Syslog Server1, Syslog Server2
• Send Log
Description
Input condition/
Display contents
• Domain Name / IP Address
Description
Input condition/
Display contents
• Port No.
Description
Input condition/
Display contents
Input the interval between each retry attempt.
1 - 300 sec.
"1.8.13 Setup Syslog" (page
Select the Syslog sending parameters.
Logs are sent in the selected RFC message format.
•
on (RFC3164)
•
on (RFC5424)
•
off
Input the domain name or the IP address of the Syslog server.
There are two methods to specify an IP address; "IPv4" and "IPv6". The following IPv6
addresses can be used; "link local address", "global address", "unique local address", or
"6to4 address". Refer to "Available IPv6 Address" (page 107)
current setting is displayed, the IPv6 address is displayed as an abbreviation.
•
For IPv4 address
xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
•
For IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
•
For domain name
Up to 63 alphanumeric characters and symbols
Input the port number used to send a Syslog.
•
Numeric characters
•
1 - 65535
720
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
132).
"Appendix B Setup Syslog" (page
for details.
982).
for details. When the
P2X0-1270-13ENZ0