Fujitsu ETERNUS DX60 S3 User Manual page 406

Chapter 4 Connectivity Management
4.2 Host Group Management
• This function is only displayed when the "Use "Add Host"" checkbox is selected for the "Function to Add
Host" field in "Web GUI Settings". This checkbox is not selected (this function is not displayed) by default.
Refer to "1.4.4 Setup Subsystem Parameters" (page 39)
• Note that this function does not create a host group. The ETERNUS DX also has a function that creates
new host groups to register hosts as its members. Refer to
details.
• Hosts that are registered with this function can belong to multiple host groups. However, only one LUN
group can be allocated to host and port combinations when configuring host affinity.
• Refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-" for each OS type to assign
an appropriate host response to the host that is to be registered. A host response has a recommended
patterns which has been prepared for each OS type. Refer to
(page 472)
If an appropriate host response is not configured to the host, the path may not be switched correctly or
the volume may not be recognized correctly.
• To change the FC host information, use the [Modify FC/FCoE Host] function. Refer to
FCoE Host" (page 423)
• The host affinity setting can be specified for each FC host. Refer to
for details.
• Both "FC host" and "FCoE host" are abbreviated as "FC host" in this section.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to register an FC host is as follows:
Procedure
1
Click [Add FC/FCoE Host] in [Action].
for details.
for details.
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
for details.
"4.2.1 Add FC/FCoE Host Group" (page 365)
"Recommended patterns of host responses"
"4.1.1 Create Host Affinity" (page 338)
"A.4.2.7 Add FC/FCoE Host" (page
"Appendix B Add FC/FCoE Host" (page
406
for
"4.2.15 Modify FC/
829).
993).
P2X0-1270-13ENZ0