Appendix A Parameter List
A.4 Connectivity Management
Input condition/
Display contents
Select "Fabric" for a direct connection when "Transfer Rate" is "16 Gbit/s". If direct connection is used for some of the
remote Fibre Channel cards, FC switches may be required. For details, refer to the Fibre Channel card specifications.
•
Set Loop ID
Description
Input condition/
Display contents
•
Loop ID
Description
Input condition/
Display contents
•
Transfer Rate
Description
Input condition/
Display contents
•
Select "Auto-negotiation", "4 Gbit/s", "8 Gbit/s", or "16 Gbit/s" for the transfer rate.
•
"Auto-negotiation" is selected for the transfer rate when the transfer rate is "16 Gbit/s" and the connection type
is changed from "Fabric" to "FC-AL".
•
Fabric
A connection type that enables simultaneous communication among multiple nodes
through a Fibre Channel switch.
•
FC-AL
A connection type that connects multiple nodes in a loop.
This connection type is used for a direct connection when the transfer rate is 8Gbit/s
or less.
When the connection type is "FC-AL", select "Manual" or "Automatic" as the specification
method for the Loop ID.
"Loop ID" is an identification number of a node in a loop.
•
Manual
•
Automatic
When "Set Loop ID" is "Manual", input the Loop ID.
When "Set Loop ID" is "Automatic", select "Ascending" or "Descending".
The Loop ID must have a value that is different from the values of all the ports.
•
When "Set Loop ID" is "Manual"
0x0 - 0x7D
•
When "Set Loop ID" is "Automatic"
-
Ascending
-
Descending
Select the transfer speed for the target port.
The available transfer rate varies according to the selected port type and connection
topology.
•
Auto-negotiation
•
4 Gbit/s
•
8 Gbit/s
•
16 Gbit/s
Note that "16 Gbit/s" cannot be selected in the following conditions:
-
SFP type is "SFP+(SMF)" or "SFP+(MMF)"
-
The connection type is "FC-AL"
843
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
P2X0-1270-13ENZ0