Fujitsu ETERNUS DX60 S3 User Manual page 705

Appendix A Parameter List
A.1 System Management
●
Allowable IP Address
• IP Address
Description
Input condition/
Display contents
• Subnet Mask
Description
Input condition/
Display contents
■
When using IPv6
●
LAN
• Speed and Duplex
Description
Input condition/
Display contents
• Wake on LAN
Description
Input condition/
Display contents
This item is not displayed when an FST port is selected.
Input the IP address (or the network address) for the remote storage system.
Up to 16 addresses can be registered.
Make sure to input the IP address (or the network address) and subnet mask in pairs.
•
Numeric characters
•
0 - 255
Input the subnet mask for the IP address (or the network address) of the remote storage
system.
•
Numeric characters
•
255.0.0.0 - 255.255.255.252
Select the communication speed and mode.
•
Automatic
•
1 Gbit/s
•
100 Mbit/s Half
•
100 Mbit/s Full
•
10 Mbit/s Half
•
10 Mbit/s Full
Select whether to "Enable" or "Disable" the WOL function (*1).
*1: The WOL function starts up the ETERNUS DX, which is connected to LAN, from
another server or a PC via network.
•
Enable
•
Disable
705
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0