Fujitsu ETERNUS DX60 S3 User Manual page 789

Appendix A Parameter List
A.3 Volume Management
• Volume No.
Description
Input condition/
Display contents
An existing volume number cannot be specified.
• Encryption by CM
Description
Input condition/
Display contents
When creating volumes (specifying a number greater than or equal to 1 for "Number of Volumes") for a RAID group
with "Online SED", "Nearline SED", or "SSD SED" as the drive type, select "Off" for this item.
When specifying the volume number for a new volume, select the "Set Value" checkbox
and input the volume number.
•
"Set Value" checkbox
-
Selected
-
Cleared
•
Volume No.
Numeric characters (decimal)
The following volume numbers can be used for each model:
-
For the ETERNUS DX60 S3
0 - 1023
-
For the ETERNUS DX100 S3
0 - 2047
-
For the ETERNUS DX200 S3
0 - 4095
-
For the ETERNUS DX500 S3/DX600 S3
0 - 16383
-
For the ETERNUS DX8700 S3/DX8900 S3
0 - 65534
-
ETERNUS DX200F
0 - 1535
Select the encryption status of new volumes.
When the encryption mode is disabled, "On" cannot be selected.
For the ETERNUS DX60 S3, this item is not displayed.
•
On
Volumes that are encrypted by a CM are created.
•
Off
Volumes that are not encrypted by a CM are created.
789
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0