Set Fc Port Qos - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.7 Host-LU QoS Management
The main setting item is as follows.
●
SAS Host QoS Setting
• Bandwidth Limit
3
Click the [Set] button.
 A confirmation screen appears.
4
Click the [OK] button.
 The SAS host QoS setting starts.
5
Click the [Done] button to return to the [SAS Host QoS] screen.
4.7.10

Set FC Port QoS

This function specifies the bandwidth limit (maximum performance limit) for the FC port.
• The bandwidth limit can be configured only for the ports in the port mode of "CA" or "CA/RA". For the ports
in the port mode of "RA" and "Initiator", the bandwidth limit cannot be specified.
• If the port mode has been changed from "CA" or "CA/RA" to "RA" or "Initiator", the bandwidth limit returns
to the default value.
• This function can be used, irrespective of whether the QoS mode has been enabled or disabled. If the QoS
mode has been disabled, the port starts the operation within the configured bandwidth limit after the
QoS mode is enabled.
• Configure the host bandwidth limit on each host. Refer to the following sections for details:
- "4.7.7 Set FC/FCoE Host QoS" (page 489)
- "4.7.8 Set iSCSI Host QoS" (page 490)
- "4.7.9 Set SAS Host QoS" (page 492)
• The LUN bandwidth limit can be configured in the LU QoS group. Refer to
482) for details.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
493
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"4.7.3 Set Host-LU QoS" (page
"A.4.6.5 Set FC Port QoS" (page
"Appendix B Set FC Port QoS" (page
End of procedure
880).
1001).
P2X0-1270-13ENZ0