Fujitsu ETERNUS DX60 S3 User Manual page 98

Chapter 1 System Management
1.8 Network Management
• If the message "Currently Network Configuration is set to factory default." is displayed in the system
message field, the network environment settings must be performed. Some functions are not available if
the network environment settings for the MNT port are incomplete. Refer to
performed in a factory default network environment" (page 98)
• When the network environment settings are the same as the factory default, all the input items in the
[IPv4 Settings] tab for the MNT port are cleared. Information that is configured in the ETERNUS DX is not
displayed. Note that in the [IPv6 Settings] tab, the information that is configured in the ETERNUS DX is
displayed.
• When SNMP Manager exists in a different subnetwork from the ETERNUS DX, specify the IP address or the
network address of SNMP Manager in "Allowable IP Address" of this function.
• Logging in again may be required after the settings are complete.
• Available operations vary depending on the models and ports. Refer to
each model" (page 99)
• MNT ports and RMT ports support both "IPv4" and "IPv6". FST ports only support "IPv4".
• Both or either "IPv4 address" and "IPv6 address" can be set for a port.
• To enable or disable each service (such as HTTP and HTTPS), use the procedure in
(page 109).
Functions that cannot be performed in a factory default network environment
• All of the [Network] navigation functions (except the [Setup Network Environment] and [Setup Firewall]
functions)
• All of the [Remote Support] navigation functions (all of the REMCS / AIS Connect functions)
• All of the [Key Management] navigation functions
• Modify RADIUS
• All of the [Audit Log] navigation functions
• Setup SMI-S Environment
• Modify Date and Time (NTP settings)
• Hot controller firmware upgrade (cold controller firmware upgrade is available)
• Add Memory
• Add Channel Adapter and Remove Channel Adapter
for details.
98
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Functions that cannot be
for details.
"Available port operations for
"1.8.2 Setup Firewall"
P2X0-1270-13ENZ0