Chapter 1 System Management
1.13 Remote Support Management (REMCS)
1.13.5
Setup Log Sending Parameters
This function transfers the internal log of the ETERNUS DX to the REMCS center.
There are two log sending methods: "Automatic" and "Manual".
•
Configure Automatic Log Transmission
The ETERNUS DX sends log periodically or when an event occurs.
•
Immediately Send Log Manually
The log is sent manually.
This function cannot be used under the following conditions:
•
When the procedure in
•
When a problem is detected in the Remote Support settings
•
When the "Receiver E-Mail Address" (REMCS center) is not specified for the Remote Support
•
The Remote Support is stopped
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
986).
The procedure to send log is as follows:
■
Configure Automatic Log Transmission
The ETERNUS DX sends log periodically or when an event occurs.
Procedure
1
Click [Setup Log Sending Parameters] in [Action].
2
Specify the parameters.
"1.13.2 Setup Remote Support" (page 193)
201
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
is not performed.
"A.1.12.4 Setup Log Sending Parameters" (page
"Appendix B Setup Log Sending Parameters" (page
773).
P2X0-1270-13ENZ0