Set Authentication Server - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.8 NAS Management
4
Click the [OK] button.
 DNS server setting starts.
5
Click the [Done] button to return to the [Environment Settings] screen.
4.8.9

Set Authentication Server

This function sets the Active Directory authentication server and the LDAP authentication server that are used
for the NAS function.
By setting the Active Directory authentication server, access to the directories and files for users can be
managed with the CIFS protocol.
By setting the LDAP authentication server, access to the directories and files for users can be managed with
the NFS protocol.
This function is used in a Unified Storage environment.
• The NAS interface settings must be performed before configuring the authentication server. Refer to
"4.8.4 Create NAS Interface" (page 508)
• Make sure to access the authentication server from both CMs (CM#0 and CM#1) to enable
communications in advance.
"Enable communication" indicates that both CMs satisfy all of the following conditions.
- An IP address is assigned to at least one port (*1)
- Communication between the port assigned with an IP address and the authentication server is
enabled (the port is in a Link up status) (*2)
*1: Refer to
*2: To check the link status, refer to "Port Detail" in "ETERNUS Web GUI User's Guide (Operation)".
• To set a new authentication server, the following information must also be specified; the domain name,
the domain administrator, and one or more servers among the three authentication servers.
• Specify the authentication server with an IP address or an FQDN. To specify an authentication server with
an FQDN, a DNS server for name resolution is required. The DNS server settings must be performed in
advance. Refer to
to use the Active Directory authentication server.
• To use the Active Directory authentication server, time synchronization is required between the ETERNUS
DX S3 series and the Active Directory authentication server. Using NTP for automatic time correction is
recommended. Refer to
• If the authentication server setup has not been completed successfully, wait for the system status to
return to normal and then try again.
• To use the CIFS protocol, set the Active Directory authentication server.
• To use the NFS protocol, set the LDAP authentication server.
• To delete the Active Directory authentication settings, clear all of the setting fields and complete the
setup.
• To delete the LDAP authentication settings, clear all of the setting fields and complete the setup.
"4.8.4 Create NAS Interface" (page 508)
"4.8.8 Set DNS Server" (page 513)
"1.4.2 Modify Date and Time" (page 34)
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
for details.
for details.
for details. Note that the DNS server must be set up
for details.
515
End of procedure
P2X0-1270-13ENZ0