A.3.11 Set Snapshot - Fujitsu ETERNUS DX60 S3 User Manual

Appendix A Parameter List
A.3 Volume Management
A.3.11 Set Snapshot
For details about this function, refer to
For the factory default settings for this function, refer to
●
Snapshot Setting
• Name
Description
Input condition/
Display contents
• Number of Generations
Description
Input condition/
Display contents
"3.19.1 Set Snapshot" (page
Input the volume name for the Snapshot destination SDV.
The following names are automatically set for SDVs in proportion to the specified
number of generations.
Input "Name" + "$snap_N" (N: Number of generations between 1 - 128)
Input the name only when executing the initial Snapshot setting.
Up to 16 alphanumeric characters, symbols (except "," (comma) and "?"), and spaces
Specify the number of Snapshot generations.
SDVs are automatically created in proportion to the specified number of generations.
The maximum number of generations for each model is as follows.
•
For the ETERNUS DX100 S3
16
•
For the ETERNUS DX200 S3
64 (*1) or 128 (*2)
•
For the ETERNUS DX500 S3
128
•
For the ETERNUS DX600 S3
256
•
For the ETERNUS DX100 S3
1 - 16
•
For the ETERNUS DX200 S3
-
1 - 64 (*1)
-
1 - 128 (*2)
•
For the ETERNUS DX500 S3
1 - 128
•
For the ETERNUS DX600 S3
1 - 128
*1: The maximum number of generations after the existing controller firmware is
updated to V10L33 or later.
*2: The maximum number of generations when the ETERNUS DX is shipped from the
factory or the maximum number of generations when adding memory (in cold
mode) after the existing controller firmware is updated to V10L33 or later.
814
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
327).
"Appendix B Set Snapshot" (page 991).
P2X0-1270-13ENZ0