Chapter 1 System Management
1.6 Eco-mode Management
•
To perform schedule operations using this function, the Eco-mode setting for the ETERNUS DX S3 series
must be enabled.
•
Disk operation time varies depending on the Eco-mode schedule settings and disk access. A disk is spun
up even if it is outside of disk operation time in the following conditions:
-
If disk access occurs while the disk motor is stopped:
The disk is immediately spun up and can be accessed within 1 - 5 minutes.
-
If a disk is activated more than a set amount of times in a day:
A state of increased access frequency is assumed and the Eco-mode will cease stopping the disk
motor.
•
To apply the created Eco-mode schedule to each RAID group, refer to the procedure in
mode Schedule (RAID Group)" (page
•
To apply the created Eco-mode schedule to each Thin Provisioning Pool, refer to the procedure in
Assign Eco-mode Schedule (Thin Provisioning Pool)" (page
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to create an Eco-mode schedule is as follows:
Procedure
1
Click [Create Schedule] in [Action].
2
Specify the schedule name, and click the [Add Event] button.
547).
77
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
584).
"A.1.5.2 Create Eco-mode Schedule" (page
"Appendix B Create Eco-mode Schedule" (page
"5.7 Assign Eco-
"6.10
693).
976).
P2X0-1270-13ENZ0