Send Snmp Trap Test - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.8 Network Management
5
Save the downloaded file.
The default file name is as follows.
• For the ETERNUS DX60 S3/DX100 S3/DX200 S3
FJDARY-E150.MIB
• For the ETERNUS DX500 S3/DX600 S3
FJDARY-E150.MIB
• For the ETERNUS DX8700 S3/DX8900 S3
FJDARY-E152.MIB
• For the ETERNUS DX200F
FJDARY-E150.MIB
 The downloaded file is saved.
6
Click the [Done] button to return to the [Network] screen.
1.8.10

Send SNMP Trap Test

This function transmits the test trap from the SNMP Agent to the SNMP Manager.
The SNMP Trap is the event information reported by the ETERNUS DX (SNMP Agent).
Perform SNMP Agent and SNMP Manager settings before executing this test.
• Perform the following settings before executing this test. If the SNMP function is disabled, the trap test
cannot be performed.
- Setup Network Environment
- Setup SNMP Agent Basic Interface
- Setup SNMP Manager
- Setup SNMP Agent MIB Access View
- Setup SNMP Agent User
- Setup SNMP Agent Community
- Setup SNMP Agent Trap
• This function transmits a test trap.
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX belongs, specify the IP
address or the network address of SNMP Manager in the "Allowable IP Address" using the procedure in
"1.8.1 Setup Network Environment" (page 97).
127
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1270-13ENZ0