Fujitsu ETERNUS DX60 S3 User Manual page 773

Appendix A Parameter List
A.1 System Management
A.1.12.4 Setup Log Sending Parameters
For details about this function, refer to
For the factory default settings for this function, refer to
986).
●
Send Log based on Events
• Send Log when Errors Occur
Description
Input condition/
Display contents
●
Send Log Periodically
• Periodical Transmission of Log
Description
Input condition/
Display contents
• Time
Description
Input condition/
Display contents
• Period
Description
Input condition/
Display contents
"1.13.5 Setup Log Sending Parameters" (page
To send logs automatically in the case of a failure, select the "Send" checkbox.
The default state of "Send Log when Errors Occur" setting will be changed to "Send" if the
Remote Support setting using the [Setup Remote Support] function has been completed.
"Send" checkbox
•
Selected
•
Cleared
To send log periodically, select the "Enable" checkbox.
The default state of "Periodical Transmission of Log" will be changed to "Enable" if the
Remote Support setting using the [Setup Remote Support] function has been completed.
"Enable" checkbox
•
Selected
•
Cleared
Specify the time when sending logs periodically.
A time between "10:00" and "15:00" is set for the default setting. (*1)
*1: Different days and times are specified in the factory settings in order to disperse
the load on the REMCS center.
•
Numeric characters
•
00 - 23
Hour
•
00 - 59
Minute
•
Undefined (10:00 - 15:00)
Different times are specified in the factory settings.
Specify the period when sending logs periodically.
•
Once per Week
•
everyday
773
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Appendix B Setup Log Sending Parameters" (page
201).
P2X0-1270-13ENZ0