Modify Date And Time - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.4 System Management
1.4.2

Modify Date and Time

This function sets the date/time and time zone (storage system location) of the internal clock in the ETERNUS
DX.
The clock is used for checking the internal log of the ETERNUS DX and in the Eco-mode, etc. The time zone
setting is used for the Remote Support function.
This function is used when moving the ETERNUS DX to a new installation site, and/or changing the system
date/time.
It is possible to setup the NTP server to automatically set the time. If the NTP server cannot be used, resetting
the time once a month is recommended.
• When the network environment is set to the factory default, the NTP function cannot be used. To perform
the network environment settings, refer to
• When using Eco-mode, make sure to set the time/date correctly.
If the date/time of the ETERNUS DX is wrong, processes for stopping and starting the disk motor cannot be
performed in accordance with the Eco-mode schedule.
• The [Modify Date and Time] function cannot be used while time synchronization with the NTP server is
being performed.
• When using the NTP server, the time modification method is the step mode (modify immediately).
• When using the NTP server, the ETERNUS DX is synchronized with the NTP server every three hours.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set the date and time is as follows:
Procedure
1
Click [Modify Date and Time] in [Action].
"1.8.1 Setup Network Environment" (page
34
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.1.3.2 Modify Date and Time" (page
"Appendix B Modify Date and Time" (page
97).
667).
972).
P2X0-1270-13ENZ0