Fujitsu ETERNUS DX60 S3 User Manual page 727

Appendix A Parameter List
A.1 System Management
• All Warning Events
Description
Input condition/
Display contents
• All Informational Events
Description
Input condition/
Display contents
• Individual Settings within Severity Level
Description
Input condition/
Display contents
• Blink Fault LED at warning
Description
Input condition/
Display contents
Select whether to notify when a warning level event occurs. When notifying, select the
notification method.
By selecting or clearing the checkbox, the same setting can be applied for all the events
displayed in the [Warning Level] tab.
Checkbox
•
Selected
Notify all the events
•
Selected (lighter colored checkbox)
Some events are notified and some events are not notified
•
Cleared
No events are notified
•
-
Not applicable to notification
Select whether to notify when an informational level event occurs. When notifying,
select the notification method.
By selecting or clearing the checkbox, the same setting can be applied for all the events
displayed in the [Informational Level] tab.
Checkbox
•
Selected
Notify all the events
•
Selected (lighter colored checkbox)
Some events are notified and some events are not notified
•
Cleared
No events are notified
•
-
Not applicable to notification
"Yes" is displayed when the target notification method ("Host Sense Key Code Qualifier",
"SNMP Trap", "E-Mail", "syslog", "REMCS" or "AIS Connect") is specified for any event in
"Error Severity Level", "Warning Level", or "Informational Level", if not, "No" is displayed.
•
Yes
•
No
Select "Enable" when setting the Fault LED in the front panel to blink while a warning
level event occurs, or select "Disable" when setting the Fault LED not to blink.
•
Enable
•
Disable
727
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0