Turn On Locator Beacon/Turn Off Locator Beacon - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 2 Component Management

2.5 Turn on Locator Beacon/Turn off Locator Beacon

2.5 Turn on Locator Beacon/Turn off Locator Beacon
This function blinks or turns off the locator beacon of CE, CM, DE, or Frontend Enclosure (FE) (only for the
ETERNUS DX8700 S3/DX8900 S3) to identify the component that requires maintenance.
In regards to the CE, DE, or FE, when instructing the LEDs to turn on/turn off, the following "IDENTIFY LED"
lamps will blink/turn off.
Controlled LEDs
Designated target component
CE
DE
FE
• When the LEDs in the CE are instructed to turn on/off, the LEDs on the front cover of the CE and the LEDs
for the CM on the rear of the CE are blinked/turned off. Note that the option to turn on/off the LEDs for a
specific component is not available. Instructing the CE LEDs to turn on/off is performed by using the
[Controller Enclosure] screen. Refer to "Controller Enclosure" in "ETERNUS Web GUI User's Guide (Opera-
tion)" for details.
• When the LEDs in the DE are instructed to turn on/off, the LEDs on the front cover of the DE, the IOM LEDs
on the rear of the DE, and the FEMs on the rear of the DE (high density DE only) are blinked/turned off.
Note that the option to turn on/off the LEDs for a specific component is not available. Instructing the DE
LEDs to turn on/off is performed by using the [Drive Enclosure Detail] screen. Refer to "Drive Enclosure
Detail" in "ETERNUS Web GUI User's Guide (Operation)" for details.
• When the LEDs in the FE are instructed to turn on/off, the LEDs on the front cover of the FE and the LEDs
for the FRT on the rear of the FE are blinked/turned off. Note that the option to turn on/off the LEDs for a
specific component is not available. Instructing the FE LEDs to turn on/off is performed by using the
[Frontend Enclosure] screen. Refer to "Frontend Enclosure" in "ETERNUS Web GUI User's Guide (Opera-
tion)" for details.
• Turning the LED of the drive on or off is instructed from ETERNUS CLI. Refer to "set led" in the "ETERNUS CLI
User's Guide" for details.
The front cover of the CE
The CM in the rear of the CE (CM#0, CM#1)
The front cover of the DE
2.5" DE
3.5" DE
The IOM in the rear of the DE (IOM#0, IOM#1)
The front cover of the DE
3.5" high density DE The IOM in the rear of the DE (IOM#0, IOM#1)
The FEM in the rear of the DE (FEM#0, FEM#1)
The front cover of the FE
The FRT in the rear of the FE (FRT#0 - FRT#3)
234
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
LED controlled target component
P2X0-1270-13ENZ0