Chapter 1 System Management
1.4 System Management
The main setting item is as follows.
●
Disk Drive Patrol Settings
•
Disk Drive Patrol
3
Click the [Set] button.
A confirmation screen appears.
4
Click the [OK] button.
The disk drive patrol starts.
5
Click the [Done] button to return to the [System Settings] screen.
1.4.12
Setup Debug Mode
This function sets the trace level to store the storage system information and the collection mode for panic
dumps when errors occur.
If you need to change the debug mode settings, follow the Support Department instructions.
•
Trace information is included in the panic dump.
•
To collect a panic dump, use the [Export/Delete Panic Dump] function. Refer to
Dump" (page 158)
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set the collection conditions for the storage system information is as follows:
Procedure
1
Click [Setup Debug Mode] in [Action].
for details.
62
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.1.3.11 Setup Debug Mode" (page
"Appendix B Setup Debug Mode" (page
End of procedure
"1.9.4 Export/Delete Panic
689).
975).
P2X0-1270-13ENZ0