Set Fc/Fcoe Host Qos - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.7 Host-LU QoS Management
4.7.7

Set FC/FCoE Host QoS

This function configures the bandwidth limit (the maximum performance limit) of the FC/FCoE host.
This function can be used, irrespective of whether the QoS mode has been enabled or disabled. If the QoS
mode has been disabled, the host starts the operation within the configured bandwidth limit after the QoS
mode is enabled.
• Configure the port bandwidth limit on each port. Refer to the following sections for details:
- "4.7.10 Set FC Port QoS" (page 493)
- "4.7.11 Set iSCSI Port QoS" (page 495)
- "4.7.12 Set SAS Port QoS" (page 496)
- "4.7.13 Set FCoE Port QoS" (page 498)
• The LUN bandwidth limit can be configured in the LU QoS group. Refer to
482) for details.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set the FC/FCoE host QoS is as follows:
Procedure
1
Select the FC/FCoE host to set the bandwidth limit (multiple selections can be made), and
click [Set FC/FCoE Host QoS] in [Action].
2
Select the FC/FCoE host bandwidth limit.
489
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"4.7.3 Set Host-LU QoS" (page
"A.4.6.2 Set FC/FCoE Host QoS" (page
"Appendix B Set FC/FCoE Host QoS" (page
879).
1000).
P2X0-1270-13ENZ0