Fujitsu ETERNUS DX60 S3 User Manual page 731

Appendix A Parameter List
A.1 System Management
• Rebuild/Copyback w/o redundant
Description
• Redundant
Description
• Complete Redundant Copy
Description
• Complete Redundant Copy of HDD Shield
Description
When the SNMP trap setting is changed from "OFF" to "ON", a message is displayed in the ETERNUS SF event log.
• Complete rebuild
Description
Select whether to notify when rebuilding or copy backing (without redundancy) (*1)
occurs for each condition shown below. When notifying, select the notification method.
•
Any Time
Notifies always when rebuilding or copy backing (without redundancy) occurs.
•
when HS<0
Notifies only when rebuilding or copy backing (without redundancy) occurs while
available hot spare disk is "0".
*1: "Rebuild to hot spare disk is started", "Rebuild to hot spare disk failed" and
"Copyback failed" are equivalent to "Without redundancy".
Select whether to notify when a redundant copy starts or ends abnormally for each
condition shown below. When notifying, select the notification method.
•
Any Time
Notifies always when a redundant copy starts or ends abnormally.
•
when HS<0
Notifies only if a redundant copy starts or ends abnormally when the available hot
spare disk is "0".
Select whether to notify when a redundant copy and isolation of the non-protected
(non-shielded) drive from the ETERNUS DX are complete. When notifying, select the
notification method.
Select whether to notify when a redundant copy and isolation of the protected
(shielded) drive from the ETERNUS DX are complete. When notifying, select the
notification method.
Select whether to notify when a bad sector (*1) is detected in the hot spare where
rebuilding is completed. When notifying, select the notification method.
*1: A bad sector is the location information (address and length) where an error such
as data reading error occurs during rebuild, copyback, or redundant copy.
731
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0