Appendix A Parameter List
A.1 System Management
For the factory default settings for this function, refer to
●
Disk Drive Patrol Settings
•
Disk Drive Patrol
Description
Input condition/
Display contents
A.1.3.11
Setup Debug Mode
For details about this function, refer to
For the factory default settings for this function, refer to
●
Master Trace Level Settings
•
Master Trace Level
Description
Input condition/
Display contents
•
Level
Description
Input condition/
Display contents
●
Trace Level by Group
•
Level
Description
Input condition/
Display contents
Select whether to "Enable" or "Disable" the disk drive patrol function.
•
Enable
•
Disable
"1.4.12 Setup Debug Mode" (page
Set the master trace level.
•
Off
Does not save a trace. Equivalent to level "0xFF".
•
Standard
The firmware trace information is saved. Equivalent to level "0x06".
•
Detail
All the firmware trace are saved. Equivalent to level "0x00".
•
Specification
The firmware traces according to the user specified level are saved.
When selecting "Specification" for the master trace level, input the trace level.
•
2-digit hexadecimal (0x00 - 0xFF)
Input the trace level for each group ID.
•
2-digit hexadecimal (0x00 - 0xFF)
689
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Appendix B Setup Disk Drive Patrol" (page
62).
"Appendix B Setup Debug Mode" (page
975).
975).
P2X0-1270-13ENZ0