Initial Setup - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management

1.1 Initial Setup

1.1 Initial Setup
This function performs the required initial settings that must be set before operating the ETERNUS DX storage
systems on a series of wizard screens.
Initial Setup is divided into "Initial Setup 1" and "Initial Setup 2".
• Initial Setup 1
Performs the minimum settings required before using the ETERNUS DX.
Refer to "Initial Setup 1" in "FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)" for details.
The "Initial Setup 1" provides the following functions.
(1) Set Storage System Name
(2) Change User Password
(3) Set Thin Provisioning
(4) Register Advanced Copy License
(5) Register SED Authentication Key
(6) Set Network Environment
• Initial Setup 2
Makes the reporting settings for when an error occurs in the ETERNUS DX. The settings can be omitted if
the reporting function will not be used.
Refer to "Initial Setup 2" in "FUJITSU Storage ETERNUS DX Configuration Guide (Web GUI)" for details.
The "Initial Setup 2" provides the following functions.
(1) Set Date and Time
(2) Setup SNMP Agent Basic Interface
(3) Setup SNMP Manager
(4) Setup SNMP Agent MIB Access View
(5) Setup SNMP Agent User
(6) Setup SNMP Agent Community
(7) Setup SNMP Agent Trap
(8) Setup E-Mail Notification
(9) Setup Syslog
If "Initial Setup 2" is not used, configure each reporting function if necessary.
27
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0