Fujitsu ETERNUS DX60 S3 User Manual page 865

Appendix A Parameter List
A.4 Connectivity Management
• Transfer Rate
Description
Input condition/
Display contents
• Reset Scope
Description
Input condition/
Display contents
• Release Reservation if Chip is Reset
Description
Input condition/
Display contents
A.4.3.9 Modify FCoE Port Parameters
For details about this function, refer to
For the factory default settings for this function, refer to
999).
●
Port Settings
• Port
Description
Input condition/
Display contents
Select the transfer speed for the target port.
•
Auto-negotiation
•
1.5 Gbit/s
•
3 Gbit/s
•
6 Gbit/s
Specify the reset scope of the target port.
Reset scope is the range where the command reset request from the server is performed,
when the target port is connected to multiple servers.
•
I_T_L (I: Initiator, T: Target, L: LUN)
Reset (cancel) the command request from the server that sent the command reset
request.
•
T_L (T: Target, L: LUN)
Reset (cancel) the command request from all of the servers that are connected to the
port.
Select whether to "Enable" or "Disable" the function to release the reserved status of the
volume when the target port (chip) is reset.
•
Enable
•
Disable
"4.3.10 Modify FCoE Port Parameters" (page
Select the target port or select the copy source port.
The selectable port locations (x: CE number, y: CM number, z: CA number, w: Port
number) are displayed as options.
•
For the ETERNUS DX8700 S3/DX8900 S3
CE#x CM#y CA#z Port#w
•
For the other models
CM#y CA#z Port#w
865
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
455).
"Appendix B Modify FCoE Port Parameters" (page
P2X0-1270-13ENZ0