Fujitsu ETERNUS DX60 S3 User Manual page 504

Chapter 4 Connectivity Management
4.8 NAS Management
• The following settings must be performed before creating shared folders.
- Create the TPPs that are to be used in the Unified Storage environment. Refer to
Provisioning Pool" (page 559)
- Create NAS user volumes. Refer to
• Confirm that the authentication server setup is complete in advance. To set the authentication server, use
the procedure in
• An error occurs when the total number of input characters exceeds the maximum (5120 characters).
Confirm the used characters when this error occurs even if the total of input characters does not exceed
the maximum. Note that a double quotation (0x22) and a single quotation (0x27) are regarded as being
two characters.
• If the shared folder creation has not been completed successfully, wait for the ETERNUS DX S3 series
status to return to normal and then try again.
When a new shared folder is created, the following setup items are automatically specified for the created
shared folder.
• "Yes (Writable)" is specified for "Writable"
• "Disable (Not use)" is specified for "Oplocks"
Note that the "Writable" and the "Oplocks" settings can be changed. Refer to
(page 506) for details.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to create shared folders as follows:
Procedure
1
Click [Create Shared Folder] in [Action].
2
Specify parameters.
for details.
"3.1 Create Volume" (page 253)
"4.8.9 Set Authentication Server" (page
504
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
for details.
515).
"4.8.3 Modify Shared Folder"
"A.4.7.1 Create Shared Folder" (page
"Appendix B Create Shared Folder" (page
"6.2 Create Thin
883).
1001).
P2X0-1270-13ENZ0