Fujitsu ETERNUS DX60 S3 User Manual page 389

Chapter 4 Connectivity Management
4.2 Host Group Management
• If the WWN is not displayed when clicking the [Rediscover] button, make sure that there is no error
in the connection environment, such as the connection between the host and the switch, and the
CA port settings of the ETERNUS DX. If there is no error in the connection environment, contact the
Support Department or manually specify the WWN.
• If an error screen appears under the following conditions, check the parameter settings.
-
-
-
-
-
-
(3)
Click the [Modify] button
 A confirmation screen appears.
■ When adding a host by manually specifying the host
(1)
Click the [Manual Input] tab.
(2)
Click the [Add] button.
 The [Add FC/FCoE Host] screen appears.
The "Host Group Name" is not entered
The "Host Group Name" does not satisfy the input conditions
The "Host Group Name" overlaps with an existing host group name (Host group names cannot
overlap with any other host group names, irrespective of the interface types.)
A host cannot recognize some LUNs
No hosts are registered in the host group, or more than eight hosts (or more than 64 for the
ETERNUS DX8700 S3/DX8900 S3) are registered
The total number of hosts has exceeded the maximum number for the ETERNUS DX
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
389
P2X0-1270-13ENZ0