Audit Log Management; Enable Audit Log - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management

1.10 Audit Log Management

1.10 Audit Log Management
This section describes audit log management.
The following functions are available with Audit log management:

• Enable Audit Log

• Disable Audit Log
• Setup Audit Log
1.10.1 Enable Audit Log
This function enables the audit log function.
• Enable the "Audit Log" setting, and then specify the destination external server. Refer to
Audit Log" (page 164)
• Note that the ETERNUS DX does not save the audit log. The audit log is only sent to the specified external
server.
The conditions for collecting audit logs are as follows:
• The interface must be ETERNUS Web GUI, ETERNUS CLI, or software that accesses the ETERNUS DX via
ETERNUS CLI or SMI-S
• The user who logs in or is newly logged in when the external server is set after the "Audit Log" is enabled
• Audit log collection target operations (*1)
*1: Refer to "Audit Log" in "ETERNUS Web GUI User's Guide (Operation)" for details about log collection target
operations.
For the factory default settings for this function, refer to
The procedure to enable the audit log function is as follows:
Procedure
1
Click [Enable Audit Log] in [Action].
If the audit log function has already been enabled, [Enable Audit Log] cannot be clicked.
 A confirmation screen appears.
for details. Audit logs are sent after the external server is specified.
162
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Appendix B Audit Log" (page
"1.10.3 Setup
983).
P2X0-1270-13ENZ0