Fujitsu ETERNUS DX60 S3 User Manual page 864

Appendix A Parameter List
A.4 Connectivity Management
●
Send ping (IP address)
• IP Address
Description
Input condition/
Display contents
• Send Number
Description
Input condition/
Display contents
• Result
Description
Input condition/
Display contents
A.4.3.8 Modify SAS Port Parameters
For details about this function, refer to
For the factory default settings for this function, refer to
●
Port Settings
• Port
Description
Input condition/
Display contents
Input the IPv4 or IPv6 address of the storage system that is used to check the connection
status of the target port.
The following IPv6 addresses can be used; "link local address", "global address", "unique
local address", or "6to4 address". Refer to
details. When the current setting is displayed, the IPv6 address is displayed as an
abbreviation.
•
For IPv4 address
-
xxx.xxx.xxx.xxx
xxx: 1 - 255 for the top field (decimal)
xxx: 0 - 255 for other fields (decimal)
-
Class must be A, B, or C
•
For IPv6 address
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx
xxxx: 0 - ffff (FFFF) (hexadecimal, alphanumeric characters)
Refer to "IPv6 Address Notation" (page 378)
Input the transmission count of the "ping" command.
1 (Default) - 10
Click the [Send] button to display the results of the "ping" commands that are sent.
•
success
All were sent successfully.
•
failed
At least one failure occurred.
"4.3.9 Modify SAS Port Parameters" (page
Select the target port or select the copy source port.
The selectable port locations are displayed as options.
CM#x CA#y Port#z (x: CM number, y: CA number, z: Port number)
864
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Available IPv6 Address" (page 107)
for details.
454).
"Appendix B Modify SAS Port Parameters" (page
for
998).
P2X0-1270-13ENZ0