Fujitsu ETERNUS DX60 S3 User Manual page 453

Chapter 4 Connectivity Management
4.3 CA Port Group Management
The main setting items are as follows.
●
Send ping (IP address)
• IP Address
• Send Number
• Result
If an error screen appears under the following conditions, check the parameter settings.
• "IP Address" and "Subnet Mask" for IPv4 are not specified
• "IPv6 Link Local Address" for IPv6 is not specified
• Some parameters do not satisfy the input conditions
• "255.255.255.255" is input for the IP address, the subnet mask, or the gateway
• The IP address and the network address are the same
• The IP address and the broadcast address are the same
• The gateway is set and the IP address and the gateway are the same
• The gateway is set and the IP Address and the gateway are not in the same subnet
• The gateway is set and the gateway and the network address are the same
• The gateway is set and the gateway and the broadcast address are the same
• When the [Discovery] button is clicked for "IPv6 Connect IP Address", the IPv6 connect IP address
can be created automatically from the prefix value that is obtained from the router that is
connected to the ETERNUS DX and the input IPv6 link local address.
• When the [Discovery] button is clicked for "IPv6 Gateway", the gateway information can be
obtained from the connected router.
• When the port mode is "CA" or "CA/RA" and Multiple VLAN is enabled, click the [Add] button to
register up to 15 IP address information for each port.
• To check whether the IP address is allocated correctly and the connection status for the remote
device, click the [Test Connection (ping)] button for "IP Address", "IPv6 Link Local Address", or "IPv6
Connect IP Address".
3
Click the [Modify] button.
 A confirmation screen appears.
4
Click the [OK] button.
 Modification of the iSCSI port parameters starts.
5
Click the [Done] button to return to the [iSCSI Port] screen.
453
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1270-13ENZ0