Setup Ssh Server Key - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.8 Network Management
1.8.14

Setup SSH Server Key

This function sets up the SSH server key that is used when encrypting communication using Secure SHell
(SSH).
SSH is used when accessing from ETERNUS CLI.
After the SSH server key setting has been changed, the information must be updated in the storage system
before accessing from ETERNUS CLI via the SSH connection. Log out from ETERNUS CLI and wait a few
minutes before logging in again.
• The SSH server key is specified in the factory settings (Key Length: 2048 bits).
• Even if the SSH server key setting has been changed, the setting PC, which has logged into ETERNUS CLI
via the Telnet connection, will not be affected.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set SSH server key is as follows:
Procedure
1
Click [Setup SSH Server Key] in [Action].
2
Specify the parameters.
The main setting item is as follows.
●
SSH Server Key Setting
• Key Length
134
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.1.7.12 Setup SSH Server Key" (page
"Appendix B Setup SSH Server Key" (page
721).
982).
P2X0-1270-13ENZ0