Modify Fcoe Port Parameters - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.3 CA Port Group Management
The main setting items are as follows.
●
Port Settings
• Port
• Transfer Rate
If some parameters do not satisfy the input conditions, an error screen appears. If this occurs, check
the parameter settings.
3
Click the [Modify] button.
 A confirmation screen appears.
4
Click the [OK] button.
 Modification of the SAS port parameters starts.
5
Click the [Done] button to return to the [SAS Port] screen.
4.3.10

Modify FCoE Port Parameters

This function sets the parameters for the FCoE host interface port that connects between the ETERNUS DX and
the host.
• The ETERNUS DX60 S3 and the ETERNUS DX200F do not support this function.
• When changing port parameters during operation, stop access from the server that is allocated to the
target port. Host access does not need to be stopped to change the port parameters of newly added CA
ports.
For more details on FCoE parameter settings, refer to "FUJITSU Storage ETERNUS DX Configuration Guide
-Server Connection-" for each OS type.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
999).
455
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"A.4.3.9 Modify FCoE Port Parameters" (page
"Appendix B Modify FCoE Port Parameters" (page
End of procedure
865).
P2X0-1270-13ENZ0