D-Link DXS-3600 Series Reference Manual page 1239

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Example
This example shows how to create a backup peer with an IP address of 2.2.2.2 and the VC ID is set by
the VPN ID.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# neighbor remote 2.2.2.1 encapsulation mpls
Switch(config-vfi)# neighbor remote 2.2.2.2 backup
Switch(config-vfi)#
111-6 pw-type
This command is used to set the type of emulated service in a VPLS. Use the no form of the command to
restore the default setting.
pw-type {raw | tagged}
no pw-type
Parameters
raw
tagged
Default
By default, this option is configured as Ethernet-tagged mode.
Command Mode
VFI Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to set the type of emulated service in a VPLS. All PWs of a VPLS should have the
same encapsulation as the emulated service type of the VPLS. The service type of a VPLS can be
modified only when there is no PW in this VPLS.
Example
This example shows how to set the service type of a VPLS to Ethernet-raw mode.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# pw-type raw
Switch(config-vfi)#
111-7 show mac-address-table vpls
Specifies that the service type is in the Ethernet-raw mode. It means
that the encapsulation of all PWs in the VPLS is in the Ethernet-raw
mode.
Specifies that the service type is in the Ethernet-tagged mode. It
means that the encapsulation of all PWs in the VPLS is in the
Ethernet-tagged mode.
1239