D-Link DXS-3600 Series Reference Manual page 1237

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
Command Default Level
Level: 12.
Usage Guideline
This command is used to set the local AC link's MTU value of a VPLS. The local AC link's MTU value can
be modified only when there is no PW in this VPLS.
Example
This example shows how to configure the local AC link's MTU value to 1000.
Switch# configure terminal
Switch(config)# l2 vfi vpls100 manual
Switch(config-vfi)# mtu 1000
Switch(config-vfi)#
111-4 neighbor remote
This command is used to create a peer in a VPLS. Use the no command to delete a peer from a VPLS.
neighbor remote IP-ADDRESS [VC-ID] encapsulation mpls [no-split-horizon]
no neighbor remote IP-ADDRESS [VC-ID]
Parameters
IP-ADDRESS
VC-ID
no-split-horizon
Default
By default, the VC ID is set by VPN ID of this VPLS and it is a network PW.
Command Mode
VFI Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to create a peer in a VPLS. Use the no command to delete a peer from a VPLS.
Example
This example shows how to create a peer, which an IP address of 2.2.2.2 and a VC ID of 100. It is a
spoke PW.
Specifies the LSR ID that is used to identify the PE to which the peer
belongs to.
(Optional) Specifies the PW ID. The range is from 1 to 4294967295. It
is used with the IP address to uniquely identify a peer for a VPLS. If
not specified, the PW ID is set by the VPN ID of this VPLS.
(Optional) Specifies that a peer is used as the spoke PW. The packets
from other PWs in the VPLS can be forwarded to this PW and the
packets from this PW can be forwarded to other PWs in the VPLS. If
this option is not specified, the peer is used as a network PW. The
packets from other network PWs in a VPLS must not be forwarded to
this PW and the packets from this PW must not be forwarded to other
network PWs in the VPLS.
1237