Table of Contents
Advertisement
Syntax Description
None.
NOTE: The shutdown form of this command disables an interface for IP routing.
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router(config-if(Vlan <vlan_id>))#
Command Defaults
None.
Example
The following example shows how to enable VLAN 1 for IP routing:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#no shutdown
12.2.2 Reviewing and Saving the Routing Configuration
Purpose
To review and save the current routing configuration, and to disable IP routing.
Commands
The commands needed to review and save the routing configuration are listed below and described
in the associated section as shown:
•
show running-config
•
write
(Section
12.2.2.2)
•
no ip routing
(Section
(Section
12.2.2.1)
12.2.2.3)
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
IP Configuration Command Set
Reviewing and Saving the Routing Configuration
12-9
Advertisement
Table of Contents
