Table of Contents
Advertisement
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Syntax Description
port-string
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to re-initialize CEP ports fe.1.3-5
Matrix>set cep initialize fe.1.3-5
11.2.6.11clear cep
Use this command to clear convergence end points parameters.
clear cep {[all | policy | detection] [port port-string {all | cisco | h323 |
siemens}]}
Syntax Description
all | policy |
detection
port port-string
cisco | h323 |
siemens
Command Defaults
None.
11-84
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Specifies the CEP-enabled port(s) to re-initialize. This must
be a port-string enabled for CEP using the set cep port
command as described in
description of possible port-string values, refer to
Section
4.1.2.
Clears all CEP parameters, or specifies that policy or
detection parameters will be cleared.
Resets the CEP default enable state to disabled on specific
port(s) for Cisco, H.323 or Siemens phone detection. For a
detailed description of possible port-string values, refer to
Section
4.1.2.
Section
11.2.6.3. For a detailed
:
Advertisement
Table of Contents
