Table of Contents
Advertisement
Command Mode
Router configuration: Matrix>Router(config-router)#
Command Defaults
None.
Example
This example shows how to change the default administrative distance for RIP to 1001:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#distance 100
13.1.1.5 ip rip offset
Use this command to add or remove an offset to the metric of an incoming or outgoing RIP route.
Adding an offset on an interface is used for the purpose of making an interface a backup.
ip rip offset {in | out} value
Syntax Description
in
out
value
Command Syntax of the "no" Form
The "no" form of this command removes an offset:
no ip rip offset {in | out}
Command Type
Router command.
Applies the offset to incoming metrics.
Applies the offset to outgoing metrics.
Specifies a positive offset to be applied to routes learned via
RIP. Valid values are from 0 to 16. If the value is 0, no action
is taken.
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
Process Overview: Routing Protocol Configuration
Configuring RIP
13-7
Advertisement
Table of Contents
